|
The parking brake cables must not be bent or
distorted. This will lead to stiff operation and premature failure.
|
| 1. |
Remove the floor console.
(Refer to Body group - "Floor console")
|
| 2. |
Disconnect the connector (A) of parking
brake switch.
|
| 3. |
Loosen the adjusting nut (A) and the parking
brake cables.
|
Parking brake lever in the car must be
in fully loosened position.
| |
| 4. |
Remove the parking brake lever assembly
after removing the bolts (A).
|
| 5. |
Raise the vehicle, and make sure it is
securely supported. |
| 6. |
Remove the rear tire and wheel.
|
| 7. |
Remove the parking brake cable (B), after
removing the clip (A).
|
| 8. |
Loosen the parking brake cable bracket bolts
and remove the parking brake cable.
|
| 1. |
Install the parking brake cable.
|
| 2. |
Install the parking brake cable (B), and
then install the clip (A).
|
| 3. |
Install the rear tire and wheel.
|
| 4. |
Install the parking brake lever assembly.
|
| 5. |
Install the parking brake
cable.
|
| 6. |
Apply a coating of the specified grease to
each sliding parts (A) of the ratchet plate or the ratchet
pawl.
Specified
grease:
Multi purpose grease SAE J310, NLGI
No.2
|
|
| 7. |
Install the parking brake cable adjuster,
then adjust the parking brake lever stroke by turning adjusting nut
(A).
Parking
brake lever stroke:
6 ~ 8 clicks (Pull the lever with 196N
(20 kgf, 44 lbf))
|
|
After repairing the parking brake
shoe, adjust the brake shoe clearance, and then adjust the
parking brake lever stroke. (Refer to "Parking brake shoe
installation") |
|
| 8. |
Release the parking brake lever fully, and
check that parking brakes do not drag when the rear wheels are
turned. Readjust if necessary. |
| 9. |
Make sure that the parking brakes are fully
applied when the parking brake lever is pulled up fully.
|
| 10. |
Reconnect the connector (A) of parking brake
switch.
|
Inspect the continuity of parking
brake switch. |
When the
brake lever is pulled:
continuity
When the
brake lever is released: no
continuity
| |
| 11. |
Install the floor console.
(Refer to Body group - "Floor console")
|
| Parking Brake
Lever Stroke Adjustment |
| 1. |
Remove the floor console tray mat
(A).
|
| 2. |
Install the parking brake cable adjuster,
then adjust the parking brake lever stroke by turning adjusting nut
(A).
Parking
brake lever stroke:
6 ~ 8 clicks (Pull the lever with 196N
(20 kgf, 44 lbf))
|
|
After repairing the parking brake
shoe, adjust the brake shoe clearance, and then adjust the
parking brake lever stroke. (Refer to "Parking brake shoe
installation") |
|
| 3. |
Release the parking brake lever fully, and
check that parking brakes do not drag when the rear wheels are
turned. Readjust if necessary. |
| 4. |
Make sure that the parking brakes are fully
applied when the parking brake lever is pulled up fully.
|
| 5. |
Install thd floor console tray mat
(A).
| |
